Carve Your Own Wooden Yo-Yo

Carve Your Own Wooden Yo-Yo

Welcome to your exclusive carving instructions, created for Victorinox by bushcraft expert Mike Pullen. Below, you’ll find the complete video tutorial, a step-by-step guide, and a downloadable PDF – perfect for carving at your own pace.

Looking for another hands-on bushcraft project? Discover how to make your own charcoal pencils.

Step-by-Step Instructions

Please enable targeting cookies to view this content.

STEP 1 Find a straight stick about 5 cm in diameter.

STEP 2 Use the saw on your Swiss Army Knife™ to cut two discs, each 2–3 cm thick.

STEP 3 Remove the bark and smooth the flat surfaces using the blade – they should be as even as possible.

STEP 4 Use the reamer to bore a hole in the centre of each disc, twisting gently until the hole is deep enough.

STEP 5 Snap a straight twig about 7 cm long – this will be your axle.

Time for a little break – you’ve earned it.

STEP 6 Cut a piece of string about 1 m long.

STEP 7 Insert one end of the string and the twig into the first disc. It should be a snug fit.

STEP 8 Attach the second disc by gently twisting it onto the other end of the twig – leaving a small gap for the string to wind.

STEP 9 Trim any excess axle with the saw.

STEP 10 Tie a loop at the end of the string, slip it over your finger, wind it up – and let it spin.

Want to keep it for later?

Get the PDF version to save or print – ideal for carving on the go.

Official Website

All available products and the best browsing experience in one place